Language selector: For information on dongle emulation, license generation, development and proof-testing of software and/or hardware protection systems, please get in touch with me at:. Contents o Dongles emulation:. 25-May-2009 ;.;. (check dongle type by photo);.;.
I'm having a problem the 9XR-Pro and the RealFlight Interface. I can't get it to recognize Channel 1 - it is always at 100. Channels 2-4 work just fine. I can fly 3-channel planes by moving channels around.
But channel 1 never works. Neither do channels 5 and beyond, although not having Channel 1 is the most limiting thing. I'm running the latest OpenTX (2.0.4). I'd love to test against my 9XR for contrast, but it's presently in for repair. Phoenix 4 is working fine on its interface through the same jack. I have the same problem on my laptop, so it would appear to be something about the interaction between the 9XR PRO and this module.
Any suggestions for debugging this problem? Helle: Thank you for your response. I do not understand what you mean by 'Problem is, they couple the PPM signal to input with a wrong capacity'. If you could try explaining it a bit more in English, I might be able to figure it out. Or you could respond in German, and I could attempt to get your German response translated. The problem with the RealFliight interface is it functions not only as an input device, but as a copy protection dongle.
So I can't build my own and hope to use it with the program. If there was something I could do to the output of the 9XR-Pro for the RealFlight model I would - I don't care if it is out-of-spec, just if it works. MikeB wrote:Try setting to 4 channels and adjusting the frame length to 12.5mS, and then try both polarities. At least, it gets me 4 channels working.
I also tried 8 channels at the minimum default of 19.2ms. This gives me 4 channels, but 5 and beyond still do not work. Here are both working (for 4 channels only) setups: Thanks to all you again - a big improvement as I can now at least fly basic models.
New Product Orange Rx DSMX/DSM2 - Frsky USB Dongle for Flight Simulator Simulators.
Does the fact that this worked suggest anything else to try that might bring further improvements? I install ersky9x in 9XR Pro and use it. I set it up this afternoon because realflight7.5 and a wired interface reached me. I say a conclusion earlier. The wired interface recognized all 8 channels and was able to use all functions prepared for by realiflight without a problem. There are some tips. Protocol PPM 8CH: 600μsec flen 20msec With all channels to 1-8, I set a servo limit to 80 According to the controller help in the web site of knifedge, I assign switch and pot to 8 channels from 5 Good luck.